Kohler KG2204 Operation page 28

MAINTENANCE
D
Figure 5-15
4. Using an oil filter wrench, remove the old oil filter
(D). See Figure 5-15.
NOTE:
After removing the oil filter, ensure that the oil cooler
adapter nut is tightened to specification, 40
ft.lbs.), and that oil cooler adapter and gasket are
seated properly .
E
Figure 5-16
5. Wipe the oil filter installation surface (E) clean with
a dry cloth. Inspect the installation surface for
damage. See Figure 5-16.
6. Apply a thin film of fresh oil to the gasket of the new
oil filter.
28 Maintenance
K0706
7. Lightly screw in the new oil filter by hand until you
feel resistance. Using the oil filter wrench (F),
tighten the filter an additional 3/4 turn
(18.4 ft.lbs.)
8. Install the oil drain plug. Tighten to specification.
Oil Pan Drain Plug Torque
N•m (29.5
20–25 N•m (14.8–18.4 ft.lb.)
9. Add fresh oil through the oil filler cap (B).
K0704
10. Check engine oil level, making sure that the level
lies between the L and F marks on the dipstick (C).
See Figure 5-18.
11. Install and tighten the oil filler cap.
12. Start the engine and run it without load for
approximately 5 minutes. This will ensure that the
fresh engine oil is distributed to each friction
surface.
NOTE:
Dispose of used engine oil and oil filters in accordance
with local environmental regulations.
F
Figure 5-17
. See Figure 5-17.
C
Figure 5-18
TP-6901 6/14
K0706
, 25 N•m
K0705