Electrical Requirements - Brant Radiant Heaters DX2-20-60 User Manual

DX2 Series
Improper installation, adjustment, alteration, service or maintenance can cause property
damage, serious injury or death. Read and understand, the installation, operating and
maintenance instructions thoroughly before installing or servicing this equipment. Only
trained, qualified gas installation and service personnel may install or service this equipment.
Not for residential use! Do not use this heater in the home, sleeping quarters, attached
garages, etc. Installation of a commercial tube heater system in residential indoor spaces
may result in property damage, serious injury or death.
Gas Requirements
Type of Gas
Natural
Liquefied Petroleum
IMPORTANT: Consult the Tube Heater General Manual for gas connection requirements.

Electrical Requirements

The DX2 Series comes standard requiring a 120VAC connection to the thermostat. An optional 24VAC
internal relay (24VAO) may be factory installed if the heater is to be controlled via a 24VAC thermostat.
A 40VA transformer is necessary when using the 24VAO option.
NOTE: A relay transformer may be used in lieu of the factory installed 24VAO option.
• 120VAC - 60 Hz GRD, 3-wire.
• 120VAC thermostat connection.
• Starting current 4.8 amps
• Running current 1.1 amps
WARNING
!
Required Manifold
Pressure
3.5 Inches W.C.
10.0 Inches W.C.
NOTICE
37
3.0 Installation
• Electrical Requirements
Minimum Inlet
Pressure
5.0 Inches W.C.
11.0 Inches W.C.
• Thermostat
Maximum Inlet
Pressure
14.0 Inches W.C.
14.0 Inches W.C.