Installing The Switch In A Rack - NETGEAR FS518 Installation Manual

Installing the Switch in a Rack

To mount the switch in a standard 19-inch equipment rack, you need these tools and materials:
• Two mounting brackets supplied from the Rack Mount Kit
• Eight screws supplied from the Rack Mount Kit to attach the mounting brackets to the switch
• Four screws and nylon washers supplied from the Rack Mount Kit to attach the mounting
brackets to the rack
• #1 Phillips screwdriver
• #2 Phillips screwdriver
To install the switch in a rack:
Attach the mounting brackets to the sides of the switch as illustrated in
1.
Hold a mounting bracket against each side of the switch and align the countersunk screw holes
in the bracket with the bracket mounting holes in the switch.
Insert the screws provided in the Rack Mount Kit through each bracket and into the
2.
bracket mounting holes in the switch.
Using a #1 Phillips screwdriver, tighten the screws to secure each bracket.
3.
Installation
Installation Guide for the Model FS518 Fast Ethernet Switch
Figure 4-1.
4-3