Installing The Switch On A Flat Surface; Installing The Switch In A Rack; Connecting Devices To The Switch; Figure 4-1. Attaching Mounting Brackets - NETGEAR GS524T - ProSafe Switch Installation Manual

• The Installation Guide
• Support Information Card

Installing the Switch on a Flat Surface

To install the switch on a flat surface, be sure to attach the rubber footpads to the
bottom of the switch.

Installing the Switch in a Rack

Refer to Figure 4-1 when installing the switch in a rack.
100/10
00 Mbps Copp
er Giga
bit Switc
h
Powe r

Figure 4-1. Attaching Mounting Brackets

Connecting Devices to the Switch

To connect the switch:
1. Connect the devices to the network ports on the switch, using Category 5 (Cat5)
or Category 5e (Cat5e) UTP cable.
Note: Ethernet specifications limit the cable length between your PC or
server and the switch to 100 m.
2. Connect one end of the AC power adapter cable to the power receptacle on the
rear panel of the switch and the other end of the power adapter cable to
the wall outlet.
installation 4-2
Ethern
et
MODEL
GS5 16T