Table of Contents
Advertisement
DVD-ROM DRIVE INSTALLATION
DVD-ROM DRIVE
INSTALLATION
Remove Server Power
Installation Manual
August, 2011
6. To remove the indicated HDD press on the red latch then carefully
swing the arm open, as indicated below.
Push the red button then,
swing the arm open.
7. Pull the HDD straight out of the carrier.
8. Insert the new HDD then, swing the arm closed. Ensure that the arm
is latched under the release button.
9. When the drive is locked into the chassis the drive should start
rebuilding. Observe the two LEDs on the front of the HDD carrier.
The green LED on the front of the drive carrier indicates drive activity.
A connection to the drive backplane enables this LED to blink on and
off when that particular drive is being accessed.
The red LED indicates two states. When blinking, it indicates the drive
is rebuilding. When solid, it indicates a drive failure.
Note:
The HDD rebuild can take several hours. The IPedge system will
continue to operate normally during the rebuild.
Important!
All HDD carries must be installed for proper cooling air
flow.
The top cover of the chassis must be opened to gain full access to the
DVD-ROM drive bay. The IPedge server accommodates only slim-line
DVD-ROM drives. Side mounting brackets are needed to mount a slim-
line DVD-ROM drive in the server chassis.
Important!
You must power down the system before installing or
removing a DVD-ROM drive. Refer to
SYSTEM" on page Chapter 6
After the IPedge server has shutdown set the power switch to OFF. On
the EM server set both rear panel power switches to OFF. Then unplug
the power cord(s).
Remove Server Power
"SHUTDOWN
–-2.
16-15
Hide quick links:
Advertisement
Table of Contents
