Chapter 12 - Gateways; Introduction - Toshiba IP edge EP Installation Manual

Chapter 12 – Gateways

INTRODUCTION

Important! To protect against transient voltages and currents, solid state secondary protectors should
be installed if there is outside wiring. These protectors shall comply with the requirements
for secondary protectors for communication circuits, UL 497A. Care must be taken to
ensure that they are well grounded to a reliable earth ground. Recommended protectors
are available in the fast Series 6 line from ONEAC Corp., (800) 327-8801. Install and test
the secondary protectors precisely to the installation instructions of the manufacturer.
Installation Manual August, 2011
The IPedge is an all IP telephony system. To interface with analog
telephones or analog CO trunks a gateway is required. The following
steps apply to the Audicodes MP118 but the general process applies to
other gateways. The Audiocodes MP118 has four analog station (FXS)
ports and four analog trunk (FXO) ports. Setting up stations and trunks
are treated separately in this section. Refer to the setup and installation
instructions for the specific gateway you are installing.
This section covers the configuration of the AudioCodes MP118 as an
FXO/FXS gateway to the IPedge server.
Analog stations are setup in two processes. First the stations are
programmed into the IPedge as SIP stations then, the gateway is setup to
act as a SIP to Analog station interface. Analog trunks are programmed in
the IPedge as SIP trunks then, the gateway is setup to act as an interface.
The VoIP/Analog gateways currently offered are shown
Table 12-1 Gateway Part Numbers
Model
MP112/2S/SIP
MP114/4S/SIP
MP118/8S/SIP
MP114/4O/SIP
MP118/8O/SIP
MP114/2S/2O/SIP
MP118/4S/4O/SIP
M1K-D1
M1K-D2
M1K-D3
VoIP Gateway Type
MediaPack 112
MediaPack 114
MediaPack 118
MediaPack 114
MediaPack 118
MediaPack 114
MediaPack 118
Mediant 1000
Mediant 1000
Mediant 1000
inTable 12-1.
Capacity
2 FXS
4 FXS
8 FXS
4 FXO
8 FXO
2 FXS, 2 FXO
4 FXS, 4 FXO
1 E1/T1
2 E1/T1
4 E1/T1
12-1