Installation Of Indoor Unit; Select Installation Location Of Indoor Unit - Gree GRS-CQ16Pd/NaB-K Owner's Manual

Description:
No Name
1 Liquid-side Service Valve
2 Gas-side Service Valve
3 Handle
4 Air discharge Grill
8.2.2 Space requirements for installation
8.2.3 Precautions on installation of outdoor unit
(1) When moving outdoor unit, it is necessary to adopt 2 pieces of long enough rope to hand the
unit from 4 directions. Included angle between the rope when hanging and moving must be
40°below to prevent center of the unit from moving.
(2) Adopt M12 bolts components to tighten feet and under frame when installing.
(3) Outdoor unit should be installed on concrete base that is 10cm height.
(4) Requirements on installation space dimension of unit's bodies are shown in following
drawing.
(5) Outdoor unit must be lifted by using designated lifting hole. Take care to protect the unit
during lift. To avoid rusting, do not knock the metal parts.

9 Installation of Indoor Unit

9.1 Select installation location of indoor unit

(1) Avoid direct sunshine.
(2) Ensure the hanger rod, ceiling and building structure have sufficient strength to support the
weight of air conditioner unit.
(3) Drainage pipe is easy to connect out.
(4) Indoor and outdoor connection pipes are easy to go outdoors
(5) Do not install at a place where flammable or explosive goods exist or flammable or explosive
gas might leak.
(6) Do not install at a place subject to corrosive gas, severe dust, salty fog, smoke or heavy
moisture.
(7) Air flow at inlet and outlet air is not blocked.
3/8 GRS-CQ12/14/16Pd/NaB-K,GRS-CQ12/14/16Pd/NaB-M
5/8 GRS-CQ12/14/16Pd/NaB-K,GRS-CQ12/14/16Pd/NaB-M
Used to cover or uncover the front case
12
Air-to-water Heat Pump
Remarks
/
2000
＞
Unit: inch