Single Level Installation - IOGear GCL1908 User Manual

Single Level Installation

In a single level installation, there are no additional switches cascaded from the
first unit. To set up a single level installation does the following:
1. Ground the GCL1908 / GCL1916 and make sure that power has been
turned off to all the computers you will be connecting.
2. Use KVM cable sets* (as described in the Cables section on page 3), to
connect any available KVM port to the keyboard, video and mouse ports
of the computer you are installing. Refer to the KVM Cable Installation
Diagrams on the following page.
3. Plug the power cable into an AC power source.
4. Turn on the power to the computers.
Single Level Installation Diagram
3
1
Note: The numbers in the diagram correspond to the numbered steps above.
* Contact your KVM dealer for ordering information.
4
2
Chapter 2. Hardware Setup
13