Gps Coordinates; Maximum Speed And Total Distance - NovaSail NS100 Operating Manual

A short press on
minutes by a long press on
When the timer reaches 0:00 it will start upcounting ('TIM up') and will indicate the
time elapsed (hours/minutes).
Note :
When the timer reaches 0:00, the display will automatically switch to the
main screen mode (unless the MOB mode is already engaged).
A short press on
and restart in downcounting mode, a long push must be applied on
the timer is stopped.
Note :
In downcounting mode, the timer will emit a beep every minute; every 10
seconds below 1 minute, every second below 10 seconds.
COG
, lower line: The course over ground as measured by the GPS receiver is
displayed. The value displayed can be averaged; see "GPS Heading sensitivity:
COG", page 14.
This mode provides the current GPS coordinates as measured by the GPS
receiver (degrees/minutes decimal).

Maximum speed and total distance

This mode provides the maximum speed recorded and the total distance.
SPM
, upper Line: Speed Max
The maximum speed is displayed in knots (KT). This value is saved when the
device is turned OFF. It can be reset by pushing the
NS100
Operating Manual
starts the downcounter.It can be re-adjusted to 5/4/1
, whether it is stopped or still running.
will stop or restart the downcounter. To reset the timer

GPS coordinates

Operations
when
button.
9