Operations; Switching Power On And Off - NovaSail NS100 Operating Manual

Hide thumbs Also See for NS100:
Table of Contents

Advertisement

Make sure the battery is installed with the correct polarity and has enough
remaining power (positive pole inserted first).
Press
Press and hold
OFF and the sequence "3", "2", "1" is finished. A beep will be emitted when
the device turns off.
Note :
If the device does not turn on, you need to check if the battery is fully
charged, that the battery compartment is dry, and the polarity is correct.
NotE :
Until enough satellites are locked, the
the modes requiring the GPS data, the screen will display "---" until it is ready. If
the number of satellites is low, the display will blink.
Note :
Alkaline batteries should be used in order to result in a maximum
lifespan of 36 hours. When using a disposable battery, it is also recommended to
remove it if the device is not used for a prolonged period of time (in order to avoid
a possible leakage inside the battery compartment).
If using rechargeable batteries, low self discharge rate battery types are
preferred, because normal rechargeable batteries lose their stored energy more
quickly. Recommended batteries are SANYO ENELOOP, GP RECYKO+ or
UNIROSS HYBRIO. These kinds of rechargeable battery will last for
approximately 25 hours.
NS100
Operating Manual

Switching power on and off

to start the device. A beep will be emitted.
for more than 4 seconds until the screen displays

Operations

NS100
is not ready to use. For all
7

Advertisement

Table of Contents
loading

Table of Contents