Positioning Belt - Pride Mobility Quantum Vibe Owner's Manual

I V . C O M F O R T

POSITIONING BELT

The positioning belt is designed to support the operator so that he/she does not slide down or forward in the seat, and it can
be adjusted for operator comfort. The positioning belt is not designed for use as a restraining device.
WARNING! The positioning belt is not designed for use as a seat belt in a motor vehicle. Nor is your power
chair suitable for use as a seat in any vehicle. Anyone traveling in a vehicle should be properly belted into
seats approved by the vehicle manufacturer.
To install the positioning belt:
You will need the following tools:
n metric/standard hex key set
n adjustable spanner
1. Insert the screw through the washer and the mounting tab at the end of the positioning belt. See figure 20.
2. Install the screw through the spacer and the large black plastic spacer, then insert the screw through the seat base rail
at the rear of the seat.
3. Install the Nylock nut to the assembly, and then tighten the screw and nut using a hex key and an adjustable spanner.
4. Repeat steps 1-3 for the other side.
NOTE: If your power chair is equipped with an optional seating system, please refer to the user manual
provided with the seat for instruction on positioning belt installation, or contact your Quantum Rehab Spe-
cialist.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt into the plastic housing on the opposite side until you hear a
click.
2. Pull the excess strap attached to the metal tab until it is secure, but not so tight as to cause discomfort.
Figure 20. Positioning Belt Installation and Adjustment
28
Black
Plastic
Spacer
Nut
Spacer
Washer
Screw
www.quantumrehab.com
A D J U S T M E N T S
Pull to Tighten
CLICK
Quantum Vibe