Positioning Belt - Pride Mobility Jazzy Owner's Manual

V . C O M F O R T A D J U S T M E N T S
To adjust the foot platform depth:
1. Remove the hardware from the foot platform
bracket. See figure 15.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform
bracket and tighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the screw. See
figure 15.
2. Turn the screw to raise or lower the front of the foot
platform.

Positioning Belt

Your power chair may be equipped with a positioning
belt that can be adjusted for operator comfort. See fig-
ure 16. The positioning belt is designed to support the
operator so that he/she does not slide down or forward
in the seat. The positioning belt is not designed for use
as a restraining device.
WARNING! The positioning belt is not designed for use as a seat belt in a motor vehicle. Nor is
your power chair suitable for use as a seat in any vehicle. Anyone traveling in a vehicle should
be properly belted into seats approved by the vehicle manufacturer.
WARNING! The positioning belt should be secured at all times. Never allow the positioning belt
to hang or drag on the floor as it may become entangled.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through the positioning belt, and into the seat base for each side
of the power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tabe on one side of the belt into the plastic housing on the opposite side until you
hear a click. See figure 16.
2. Pull the excess strap attached to the metal tabe until it is secured, but not so tight as to cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the power chair and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose parts or damage, including tears, worn spots,
bent hardware, damaged latch mechanisums, dirt or debris, before each use of the power chair.
If you discover a problem, contact your Quantum Rehab Provider for maintenance and repair.
Quantum/Jazzy 1450 Series
Figure 16. Positioning Belt Adjustment
www.pridemobility.com 19