Pride Mobility Quantum Vibe Owner's Manual page 35

V I . O P E R A T I O N
NOTE: If you turn on the power chair while it is locked and don’t unlock it after one minute, the power chair
will automatically turn off itself.
Battery Condition Meter
The battery condition meter consists of six lights arranged in an arc over the battery icon. From left to right, the first two are
red, the second two are orange and the last two are green. These lights give you an accurate indication of your usable
battery capacity. If the battery has at least 85% of its rated capacity, all of the lights will be on. As the battery voltage drops,
the number of lights reduces from right to left. When the battery capacity drops to 10% or below, all of the lights will flash
once every second.
Drive Program Select Key
The drive program select key enables you to select a drive program and an actuator mode. Your Dynamic DX controller
was preprogrammed at the factory for five drive programs— 1 (slowest) to 5 (fastest). The drive mode is indicated by a
number in the drive mode and actuator display in the center of the keypad.
NOTE: The drive mode settings are preset at the factory. If your Quantum Rehab Specialist changes these
settings, please make note of these changes.
To change the drive mode program:
1. Press the drive program select key.
2. Move the joystick right to increase the drive mode program.
3. Move the joystick left to decrease the drive mode program.
4. Press the drive program select key.
Drive Mode and Actuator Display (also Remote Status Display)
This is a seven-segment light that displays the drive program. It also displays a drive inhibit and actuator mode (if applicable),
when they occur. This light will flash if there is an internal Dynamic DX Remote fault, or if an OONAPU fault has occurred.
See “Out Of Neutral At Power Up.”
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate
them through the remote keypad. Contact your Quantum Rehab Specialist for information on how to operate these
accessories.
Horn Key
The horn key activates the horn.
Battery Saver Feature
When the battery capacity drops to below 21V (typically two lights on the battery condition meter), the controller will
reduce power chair performance to conserve battery power.
Off-board Charger/Programming Socket
You charge the power chair batteries through the 3-pin socket located on the front of the Europa. Off-board charger
current should not exceed 12 amps. Contact your Quantum Rehab Specialist for more information.
Quantum Vibe www.quantumrehab.com 35