Positioning Belt - Pride Mobility LUXOR Owner's Manual

V . C O M F O R T
To change the controller position:
1. Loosen the lever. See figure 26.
2. Slide the controller to the desired position.
3. Tighten the lever.
The controller can be placed on either the right or left side
of the power chair.

Positioning Belt

Your power chair may be equipped with a positioning belt
that can be adjusted for operator comfort. See figure 27.
The positioning belt is designed to support the operator so
that he/she does not slide down or forward in the seat.
The positioning belt is not designed for use as a restraining
device.
To remove/install the positioning belt:
1. Remove the seatback screws that attach the seat canes
to the frame.
2. Cut the tie-wraps that fasten the seatback to the frame.
3. Remove the seat canes.
4. Slip each end of the belt up and over the frame.
5. Reinstall the seatback screws.
6. Install one tie-wrap on each side of the seatback.
To adjust the positioning belt:
1. When seated, insert the metal tab into the plastic housing
on the opposite strap until you hear a click.
2. Pull the strap until it is secure, but not so tight as to
cause discomfort.
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning
belt is properly secured to the power
chair and is adjusted for operator
comfort before each use.
MANDATORY! Inspect the positioning
belt for loose or damaged parts before
each use of the power chair. If you
discover a problem, contact your
a u t h o r i z e d P r i d e P r o v i d e r f o r
maintenance and repair.
26
A D J U S T M E N T S
POSITIONING
BELT
Figure 27. Positioning Belt
www.pridemobility.com Luxor