Table of Contents
Advertisement
Auxiliary Controls
The Rodgers T807 is equipped with stereo auxiliary input jacks (one for the left channel and one
for the right channel) located on the connector panel under the keydesk to the right. When using
these input jacks, audio signals from other sound generating devices like synthesizers, MIDI
sound modules, and tape players are mixed into the organ's main audio system. A series of
menus in the Audio Controls category are used to adjust the characteristics of the auxiliary
inputs.
Note: Public address systems should NOT be connected through the organ's audio system.
Adjusting Auxiliary Inputs
1. Press and hold the SET piston.
2. Turn the Select knob clockwise (right) to the Audio Controls category.
3. Release SET.
4. Turn the Select knob to display one of the five Aux menus and its setting.
A u d i o C o n t r o l s
A u x I n
V O L U M E
0. 0 0
5. Rotate the Alpha dial to change the setting.
6. Turn the Select knob to move to the next menu item, if desired and repeat step 5.
Note: An Audio Save may be performed to save this setting as the default. See Audio Save on
page 23.
Room Modeling
The sound we normally hear allows us to perceive the distance from the sound source because it
is a combination of two different types of sounds: The sound that reaches our ears directly and
the sound that reaches us with some delay after it reflects off of walls and surfaces. A component
of Dimensional Sound Modeling, the RSS
Room Modeling system produces a sense of distance
and surface materials for the sound and its reflection.
On the T807, the Room Modeling menus allow you to specify size of room, wall coverings,
level, bass, treble, and front/rear balance. These menus can be accessed via QuickMenu or by
holding SET and turning the Select knob clockwise to the Room Modeling menu.
Setting Room Modeling
1. Press and hold the SET piston.
2. Turn the Select knob clockwise (right) to the Room Modeling category.
3. Release SET.
24
Advertisement
Table of Contents
