Connecting The Monitor; Power & Signal Connections - i3TOUCH Excellence User Manual

2. Connecting the Monitor

The procedures for setting up your Monitor kit is as followed:
2-1 Power & Signal Connections
2-1. Power cord connection:
Connect the power cord to the AC outlet.
2-2. Power on:
Switch on the main power of your monitor (switch is located next to the AC outlet)
2-3. Input Source VGA (HDMI1/ HDMI2/ HDMI3) Signal cable connection:
Plug one end of the 15-pin signal cable to the video signal connector at the rear of the PC/laptop system (or engine box) and
the other end to the monitor. Or plug one end of the HDMI signal cable to signal source (PC, laptop, IPC, media player of any
kind with proper HDMI or other out port), and the other end to the HDMI connector on the monitor.
Tighten the connector screws on both ends of the cable to secure good signal connection.
2-4. VGA/ HDMI output connection (Optional male to male VGA/ HDMI cable):
Plug one end of the VGA/ HDMI signal cable to signal source and the other end to another VGA/ HDMI in connector to dai-
sy-chain, of cascading, signal to the other monitor.
Tighten the connector screws on both ends of the cable to secure good signal connection.
2-5. USB cable connection (for touch monitor models):
Plug one end of the USB (B type) cable to the USB (A type) connector at the rear of the (PC, or, IPC, or, media player), and the
other end to the USB connector on monitor.
There are two USB (B type) connecters, one for dynamic source (VGA/ HDMI1/ HDMI2) on rear, the other for HDMI3 on side.
Please connect the signal source first, then follow by connecting USB cable for touch.
For Operating Systems other than Windows 7 or Windows 8, drivers are required. Please download the latest
drivers at www.i3-learning.com
6 i3TOUCH EXCELLENCE Monitor User Guide Version 3.6.1