Gibson G FORCE Owner's Manual page 8

String slot shaft (where to feed the string up toward the thread) with an approximate 45 degree angle.
5. When you wrap the string around the top part of the post, wind it directly on top of the
flange, not partway up the upper part of the post. Wrap two full turns for the B and high e
strings.
Wind the strings in the same direction (clockwise) as the direction of tightening the machine head cap.
Make sure to wrap two full turns with the B and high e string before tightening the cap.
6. After wrapping the string around the top part of the post, pull it tight with one hand as you
screw on the cap with the other hand.
7. Screw the cap on as tight as you can with your fingers, then use a penny to give an
th
additional 1/8
8. Use String Up mode (see page 11) to tune the string.
8 | P a g e
turn. Do not overtighten!