Table of Contents
Advertisement
• The tumble dryer must be installed in a
clean place, where dirt does not build up.
• Air must be able to circulate freely all round
the appliance. Do not obstruct the front
ventilation grille or the air intake grilles at
the back of the machine.
• Important! To keep vibration and noise to
a minimum when the dryer is in use, it should
be placed on a firm, level surface.
• Once in its permanent operating position,
check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or
lower the feet until it is.
• Important! The feet must never be
removed. Do not restrict the floor clearance
through deeply carpets, strips of wood or
similar. This might cause heat built-up which
would interfere with the operation of the
appliance.
Important! The hot air emitted by the
tumble dryer can reach temperatures of up to
60°C. The appliance must therefore not be
installed on floors which are not resistant to
high temperatures.
When operating the tumble dryer, the room
temperature must not be lower than +5°C
and higher than +35°C, as it may affect the
performance of the appliance.
Warning! Should the appliance be
moved, it must be transported
vertically.
Warning! The appliance must not be
installed behind the lockable door, a
sliding door or a door with a hinge on
the opposite side to that of the
appliance.
Removing transport
safety packaging
Caution! Before use all parts of the
transport packaging must be removed.
1. Open loading door.
2. Pull off adhesive strips from inside machine
on top of drum.
3. Remove foil hose and polystyrene padding
from the machine.
Fitting the vent hose
To simplify the installation, there is a choice of
vent outlets: one at the back, the others in the
left and right-hand side. Connect the hose to
whichever is the more convenient by pulling
the ring nut (A) from the vent outlet at the
back, screwing it on to the hose and pushing
it firmly back into place. The unused vents
24
Hide quick links:
Advertisement
Table of Contents
