John Lewis JLDV 09 Instruction Manual page 19

Loading door does not close.
When a button is pressed, Err
appears on the LCD.
Drum light does not work.
Displayed programme time
changes erratically or stays
unchanged for a long time.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends
automatically.
Changing the bulb for
interior lighting
Only use a special bulb which is designed
specially for dryers. The special bulb can be
obtained from your local Service Force
centre.
Warning! When the appliance is
switched on, the interior lighting
switches itself off after 4 minutes when
the door is open.
Warning! Do not use standard bulbs!
These develop too much heat and may
damage the machine!
Residue on inside surface of
drum or drum ribs.
Conductance of water at
installation site differs from
standard setting of machine.
Filter not in place.
Washing protection. After the
start of the programme, the
option can no longer be set.
Programme selector in OFF
position.
Defective light bulb.
Programme time is corrected
automatically depending on type
and volume of laundry and level
of dampness.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
1. Unscrew cover above the bulb (this can
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket
before screwing back the door light cover. Do
not operate the dryer when missing o-ring
gasket on door light cover.
19
Clean inside surface of drum and
drum ribs.
Re-programme standard setting
for degree of drying (see
'Programming options' chapter).
Install filter into place.
Turn the programme knob to
OFF . Set the programme again.
Turn programme selector to any
programme.
Replace light bulb (see next
section).
Automatic process; this is not a
machine fault.
Select time programme or higher
drying level (e.g. EXTRA DRY
instead of CUPBOARD DRY ).
Clean filter.
Reduce load volume.
Laundry must be adequately
spun.
Warning! Before replacing the bulb,
disconnect the mains plug.
be found directly behind the loading
aperture, at the top; refer to "Description
of machine" section.)