Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for John Lewis JLTDC11
Summary of Contents for John Lewis JLTDC11
- Page 1 JLTDC11 Condenser dryer with heat pump Instruction manual...
-
Page 2: Important Safety Information
These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. If you are unsure of the meanings of these warnings contact the John Lewis branch from which you purchased the appliance. -
Page 3: Tumble Dryer
• If you have washed your laundry with stain remover you must execute an extra rinse cycle before loading your tumble dryer. • Please make sure that no gas lighters or matches have accidentally been left in pockets of garments incase they are loaded into appliance Warning! •... -
Page 4: Child Safety
• Fabric softeners, or similar products should be used as specified by the fabric softener instructions. • Caution - hot surface : Do not touch the door light cover surface when the light is switched on. (Only dryers equipped with internal drum light) Child safety •... - Page 5 product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local council, your household waste disposal service or the shop where you purchased the product.
-
Page 6: Table Of Contents
Contents For the user Important safety information Description of the appliance Control panel Before first use Programme chart Sorting and preparing laundry Daily use Switching machine on Door opening and laundry loading Selecting the programme Extra delicate Intensive Anti-crease Alarm Time Delay start Setting child lock... -
Page 7: Description Of The Appliance
Description of the appliance Control panel Water reservoir Drum light Fine fluff filter Fluff filter Loading door (reversible) Rating plate Course fluff filter Heat exchanger cover Push button for base door opening Ventilation grille Adjustable feet... -
Page 8: Control Panel
Control panel Programme selector and Off switch Extra delicate button Intensive button Anti-crease button Alarm button Time button Before first use Warning! If the appliance was not transported in an upright position, leave it to stand for 12 hours before connecting it to the electricity supply and using it for the first time, so that the oil can flow back to the... -
Page 9: Programme Chart
Programme chart Programmes Cottons Extra dry 7 kg Cottons Store 7 kg Cottons 7 kg Cupboard dry Cottons Damp 7 kg Cottons Iron dry 7 kg Synthetics Extra 3 kg Synthetics 3 kg Cupboard dry Synthetics Iron 3 kg Time 7 kg 1 kg Easy iron... -
Page 10: Sorting And Preparing Laundry
Programmes Wool care 1 kg Refresh 1 kg Sorting and preparing laundry Sorting laundry • Sort by fabric type: – Cotton/linen for programmes in Cottons programme group. – Mixtures and synthetics for programmes in Synthetics programme group. • Sort by care label: The care labels mean: Drying in the tumble dryer possible in principle Drying at normal temperature... -
Page 11: Daily Use
Daily use Switching machine on Turn the programme selector to any programme. The machine switches on. When the loading door is open, the internal lamp illuminates the drum. Door opening and laundry loading 1. Open loading door: Push against the loading door (push point) 2. -
Page 12: Intensive
To deselect the function press the Extra delicate button again. LED above is off. Intensive If the laundry is still damp after a standard drying programme, you can increase the drying result by using the Intensive function. 1. Choose the drying programme. 2. -
Page 13: Delay Start
1. Turn the programme selector to the Time programme. The flashing 10' above the Time button is on. 2. Press the Time button repeatedly until the desired programme duration is shown in the display, e.g. 20 for a programme of 20 minutes. -
Page 14: Starting The Programme
Starting the programme Press the Start/Pause button. The programme starts. The programme progress is shown by elapsing Dry time on LCD. Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to Off and then reset the programme. -
Page 15: Maintenance And Cleaning
The drying cycles are automatically followed by an anti-crease phase which lasts around 30 minutes. The drum rotates at intervals during this phase. This keeps the laundry loose and free of creases. The laundry can be removed at any time during the anti- crease phase. - Page 16 Push down the unlock button on the large mesh filter. The large mesh filter pops up. Take out fine filter. Remove the fluff from fine filter. It is best to use a damp hand for this purpose. Clean the entire filter area The filter area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned...
-
Page 17: Cleaning The Door Seal
If the fine filter is not fitted, the large mesh filter will not snap into place and the loading door cannot be closed. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. Emptying the water reservoir Empty the water reservoir after every drying... -
Page 18: Cleaning Heat Exchanger Filters
Cleaning heat exchanger filters If the warning lamp Condenser lights, the heat exchanger fluff filters in the base of the appliance must be cleaned, i.e. after each 5 drying cycles. Both filters are located in the appliance base. Water can collect in the filter housing therefore it is normal for the heat exchanger fluff filters to become wet. -
Page 19: Cleaning The Drum
4. Use a damp hand to remove the fluff from the filter in the base . If necessary pull out and clean the filter with warm water using a wiper or brush. Clean the inside of the door, the fluff filter chamber and the rubber seals of fluff. -
Page 20: Clean Operating Screen And Housing
Clean operating screen and housing Caution! Do not use furniture cleaners or aggressive cleaning agents to clean the machine. Use a damp cloth to wipe down the operating screen and housing. What to do if ... Problem Dryer not connected to mains supply. Dryer does not work. -
Page 21: Machine Settings
Drying cycle Small laundry volume./Too dry laundry to short for selected programme. Fluff filters clogged. To high loading volume. Drying cycle Laundry insufficiently spun. to long Particularly high room temperature - no machine fault. 1) In case of error message on the LCD (e.g. E51 ): Switch the dryer off and on. Set programme. Press the Start/ Pause button. - Page 22 Adjusting the level of conductivity Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of the cycle.
-
Page 23: Technical Specifications
Technical specifications This appliance conforms with the following EU Directives: – 2006/95/EC dated 12.12.2006 Low Voltage Directive – 89/336/EEC dated 03.05.1989 EMC Directive inclusive of Amending Directive 92/31/EEC – 93/68/EEC dated 22.07.1993 CE Marking Directive Height x width x depth Drum volume Depth with loading door open Height can be adjusted by... -
Page 24: Installation
Installation Transporting the appliance Important! Only tip the appliance on its left side to transport (see illustration), if it cannot be transported in an upright position. Appliance positioning • It is recommended that, for your convenience, the machine is positioned close to your washing machine. -
Page 25: Removing Transport Safety Packaging
Important! • The appliance should not be installed in an environment such as a unheated garage or outbuilding. The combination of high humidity and low ambient temperatures could affect the performance or the appliance and therefore invalidate your guarantee. • The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. - Page 26 Warning! THIS APPLIANCE MUST BE EARTHED. Should the appliance power supply cable need to be replaced, this must be carried out by a Service Force agent (see chapter: Repairs - after sales service). The manufacturer declines any liability should this safety measure not be observed.
-
Page 27: Door Reversal
Warning! The door must only be reversed by an authorised service engineer. Please contact your nearest John Lewis branch who will give you details of your local Service Force Centre. The engineer will carry out the door reversal at your cost. -
Page 28: Spare Parts
An authorised service engineer should service this product, and only genuine spare parts should be used. Under no circumstances should you attempt to repair the appliance yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local John Lewis branch. - Page 32 John Lewis Partnership 171 Victoria Street London SW1E 5NN www. johnlewis.com 136909381-00-102009...