Table of Contents
Advertisement
3 3 / USING YOUR APPLIANCE
CONTROL PANEL DESCRIPTION
•
On/Off
Pressing the
A long press on the
•
Cartridge filter saturated
The
button flashes (1 short flash) for 2 minutes after the hood stops to signal that the
cartridge filters must be cleaned (see section "Cleaning the cartridge filter").
Give a long press (more than 2 sec) on
•
Carbon filter saturated
The
button flashes (2 short flashes) for 2 minutes after the hood stops to signal that
the carbon filters must be cleaned (see section "Changing the carbon filter").
Give a long press (more than 2 sec) on
•
Change speed
Once the hood has started, you can modify the suction speed by pressing
speed 2 (
The
function allows your hood to remain at maximum speed 4 for 10 minutes,
before switching back to speed 2.
•
Configure recycling mode (or evacuation mode as an optional extra)
A long press (more than 2 sec) on the
Evacuation or Recycle mode. The
flashes.
A short press on
off).
A short press on
button is off.
A short press on
The hood's default mode is evacuation.
button starts the hood in speed 1 (the
button turns the hood off.
is lit) or
for speed 3 (
selects recycle mode (the
selects evacuation mode (the
confirms the configuration (or automatic set after 10 sec).
to unlock the "saturation" function.
to unlock the "saturation" function.
is lit).
and
and
buttons are lit and the
button flashes and the
11
button is illuminated).
buttons allows you to select
or
button flashes and the
EN
for
button
button is
Advertisement
Table of Contents
