Download Print this page

Figure 6 - Dielectric Strength Testing - RuggedCom RuggedServer RS910 Installation Manual

2-port serial device server with up to 3 ports managed ethernet switch

Hide thumbs Also See for RuggedServer RS910:

Table of Contents

2.2.3 Dielectric Strength Testing

Units which are to have dielectric strength testing (HIPOT testing) done in the field must have the

braided ground cable disconnected during the test. This is required in order to prevent the surge

suppression circuitry, which is connected to surge ground, from being activated.

Figure 6 - Dielectric Strength Testing

Rev100

Table of Contents

Do you have a question about the RuggedServer RS910 and is the answer not in the manual?