Table of Contents
Advertisement
2.7 Connecting to AC Mains
Connect your amplifier to the AC mains power source (power outlet) with the
supplied AC power cord. First, connect the IEC end of the cord set to the IEC
connector on the amplifier; then, plug the other end of the cord set to the AC mains.
WARNING: The third prong of this connector (ground) is an important safety feature.
Do not attempt to disable this ground connection by using an adapter or other
methods.
Amplifiers don't create energy. The AC mains voltage and current must be sufficient
to deliver the power you expect. You must operate your amplifier from an AC mains
power source with not more than a 10% variation above or below the specified line
voltage and within the specified frequency range indicated on the back panel of the
amplifier. If you are unsure of the output voltage of your AC mains, please consult
your electrician.
2.8 Protecting Your Speakers
It's wise to avoid clipping the amplifier signal. Not only does clipping sound bad, it
can damage high-frequency drivers. The built-in clip limiter prevents clipping.
Also, avoid sending strong subsonic signals to the amplifier. High-level, low-
frequency signals from breath pops or dropped microphones can blow out drivers.
You can switch on the highpass filters, and this avoids to send subsonic signals
under 70 Hz to the amplifier. Use of the high-pass filter is necessary when using the
CST2120 transformer module to drive a 70V or 100V distributed loudspeaker system
in order to prevent distortion due to transformer saturation.
2.9 Startup Procedure
Use the following procedure when first turning on your amplifier:
1.
Turn down the level of your audio source.
2.
Turn down the level controls of the amplifier.
3.
Power up the amplifier. The Power indicator should light.
4.
Turn up the level of your audio source to an optimum level.
5.
Turn up the Level controls on the amplifier until the desired loudness or power
level is achieved.
If you ever need to make any wiring or installation changes, don't forget to
disconnect the power cord.
13
Advertisement
Table of Contents
