Interactive Display; Viewing Modes; Basic Operation - iConnectivity iConnectAudio 4+ Owner's Manual

Interactive Display

+
The iConnectAUDIO4 's Interactive Display makes it simple to view and adjust analog
input and output levels, enable/disable 48V phantom power for condenser mics, and
perform various utility functions without using the iConfig software.
It consists of a capacitance touch panel with eight touch zones and dual 8-stage LED
meters; and a Rotary Control Knob that also performs various functions when it's
pushed/double-pushed.

Viewing Modes

There are two viewing modes. Successive touches of a bottom row touch zone (except
48V) toggles between the two.
- Signal Level mode, indicated by a green bottom row LED. The LED meters display
VU (the signal level).
- Gain Set mode, indicated by a red bottom row LED. This is like showing the position
of a volume control (the Rotary Knob is continuous, so otherwise you wouldn't know
where it is).
The 48V touch zone has no effect on the viewing mode, since it's an on/off function
rather than a level setting.

Basic Operation

1. Touch the region centered around one of the four functions on the bottom row to
select it: 48V, In, Out, or Phones.
2. Touch numbers 1 through 4 on the top row to select that analog input or output for
adjustment (or to turn 48V phantom power on/off).
3. Turn the Rotary Knob to adjust the In, Out, or Phones level.
Example: adjust the level of Analog Outs 1&2, which are connected to your powered
monitors.
v.1.0
15