Mitsubishi Electric PURY-80TMU Service Handbook page 33

SET TEMP.
CLOCK ON OFF
MODE TIMER
PAR-F27MEA-US TIMER SET
2 Press the switch for
confirmation (E)
3) Method of deletion
• Deletion of group registration information of indoor unit ...................................... 4
[Operation procedure]
1 With the remote controller under stopping or at the display of "HO", continuously press the
button (A + B) at the same time for 2 seconds to change to the registration mode.
2 Press the button (E) to display the indoor unit address registered. (As same as 2)
TIMER
3 In order to delete the registered indoor unit being displayed on the remote controller, press the
(F) button two times continuously. At completion of the deletion, the attribute display section will be shown as " – – ".
(See figure below.)
Note: Completing the deletion of all indoor units registered on the remote controller returns to "HO" display.
4 After completing the registration, continuously press the
seconds to change to the original ordinary mode (with the remote controller under stopping).
SET TEMP.
CLOCK ON OFF
MODE TIMER
TIMER SET
PAR-F27MEA-US
1 Press the switch for confirmation (F)
twice continuously.
ON/OFF
FAN SPEED AIR DIRECTION FILTER
LOUVER VENTILATION CHECK TEST
1 Set the address
1
ON/OFF
FAN SPEED AIR DIRECTION FILTER
LOUVER VENTILATION CHECK TEST
• Registered
1 + 2
• No registration
+
FILTER LOUVER
• Deletion completed
In case of group re-
gistration with other
indoor unit is existing
• Deletion completed
1
In case of no group
registration with other
indoor unit is existing
–32–
ßC
(Alternative
display)
ßC
ßC
(Alternative
display)
ßC
˚C
INDOOR UNIT ERROR CODE
ADDRESS NO OA UNIT ADDRESS NO
* Same display will appear when
the unit of "007" is not existing.
˚C
ERROR CODE
OA UNIT ADDRESS NO
+
FILTER LOUVER
CLOCK → ON → OFF
TIMER
button (A + B) at the same time for 2
˚C
INDOOR UNIT ERROR CODE
ADDRESS NO OA UNIT ADDRESS NO
"– –" indicates the
deletion completed.
˚C
INDOOR UNIT ERROR CODE
ADDRESS NO OA UNIT ADDRESS NO
2