Fen - Eneo PNR-5316 User Manual

Part 3 - Configuration
1
Enter the IP address of the NVR.
2
Adjust the frequency of the ping test.
3
Select Run to do the test. The test result is displayed.
4
Select Close to exit.
• If using a firewall, select Change Port to change the
port number to one that is permitted by the firewall.
• Changing the port temporarily severs the NVR's
remote connection.
Remote point IP and port settings on the remote
program must also be changed in order for it to
connect to the NVR.
• To use the UPnPWE (Universal Plug and Play) feature, select
Use UPnP. If using an IP router (or NAT), UPnP service
allows the device to automatically forward the port to the
NVR.
• This port is used to access a port that has a private
IP address.
• In order to use the UPnP service, the IP router (or
NAT) must support UPnP port forwarding and have
the relevant options enabled.
• Port number cannot be changed with Use UPnP
selected.
• Status: Indicates the number of the port forwarded by
the IP router (or NAT) to the NVR via UPnP service.
DHCP
Select DHCP and then Save to retrieve IP address and
other network settings automatically from the DHCP
server. Once the network settings have been retrieved,
the NVR's current IP address is displayed in the IP
Address field.
52
• It may not be possible to retrieve the IP address if
there is no DHCP server. If this is the case, contact
your network administrator.
• With DHCP, the NVR's IP address might change
with each startup.
There is a limit to the number of users allowed to
connect remotely at the same time. Contact the
service center for more information.

FEN

If using a dynamic IP address, FEN service makes it easy
to connect to the NVR from a remote program without
having to configure dynamic IP or router settings.
• Use FEN: Check if you wish to use FEN service.
• FEN Server: Enter the FEN server's IP address or
domain name.
If you have configured the DNS Server setting under
Network - IP Address, you can enter the FEN server's
domain name instead of its IP address in the FEN
Server field.
• Port: Specify the FEN server's port number.
If using an IP router (or NAT), port configuration and
other network functions will depend on the usage
method of the IP router (or NAT).
Device Name: After entering the NVR name you wish
to register on the FEN server, check and register the
entered name. This is a unique NVR name that will be
registered on the FEN server.