L2Tp - D-Link DIR-640L User Manual

Section 3 - Configuration
Choose L2TP if your ISP uses a L2TP connection. Your ISP will provide you with a username and password.
My Internet
Connection Is: Select L2TP from the drop-down menu.
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic.
PPTP IP Address: Enter the IP address for your L2TP connection.
PPTP Subnet Mask: Enter your L2TP subnet mask.
PPTP Gateway IP
Address:
Enter the gateway IP address for your L2TP connection.
PPTP Server IP
Address: Enter the server IP address for your L2TP connection.
User Name: Enter your L2TP user name.
Password:
Enter your L2TP password and then retype the password in the next box.
Select either Always-on, On-Demand, or Manual.
Reconnect Mode:
Maximum Idle Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable
Time: auto-reconnect.
DNS Addresses: Enter the primary and secondary DNS server addresses (static L2TP only).
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the default
MTU.
MAC Address: The default MAC address is set to the Internet port's physical interface MAC address on the broadband router. It is not recommended
that you change the default MAC address unless required by your ISP.
D-Link DIR-640L User Manual

L2TP

25