D-Link DIR-640L User Manual page 16

Section 2 - Installation
4. Plug one end of the included blue Ethernet cable that came with your router into the yellow port labeled
INTERNET on the back of the router. Plug the other end of this cable into the Ethernet port on your modem.
5. Reconnect the power adapter to your cable or DSL broadband modem and wait for two minutes.
6. Connect the supplied power adapter into the power port on the back of the router and then plug it into a power
outlet or surge protector. Press the power button and verify that the power LED is lit. Allow 1 minute for the
router to boot up.
7. If you are connecting to a broadband service that uses a dynamic connection (not PPPoE), you may be online already.
Try opening a web browser and enter a web site. If you connect, you are finished with your Internet setup. Please
skip to "Manual Internet Connection" on page 20 to configure your router and use the manual setup procedure to
configure your network and wireless settings. If you did not connect to the Internet, use the "Web Setup Wizard"
on page 12.
D-Link DIR-640L User Manual
DIR-640L
COM POWER
DIR-640L
COM POWER
Modem
11