Qos Tab - Basler BIP2-XXXXc User Manual

AW00097209000
Commit
- Click the Commit button to save any changes you have made to the RTSP settings.
Revert
- Click the Revert button to cancel any changes you have made to the RTSP settings. The
settings will revert to what they were the last time that the Commit button was clicked.
3.8.3

QoS Tab

The parameters on this tab are used to set network traffic prioritization settings, commonly known
as QoS or Quality of Service settings. Note that these settings will only have an effect on networks
where all network switches and routers support QoS.
Normally, these settings should only be adjusted by a network administrator.
Commit
- Click the Commit button to save any changes you have made to the QoS settings.
Revert
- Click the Revert button to cancel any changes you have made to the QoS settings. The
settings will revert to what they were the last time that the Commit button was clicked.
3.8.4 I/O Tab
Basler IP Fixed Box Cameras
HTTP DSCP
- Sets the HTTP DSCP (differentiated services code
point) value.
RTSP DSCP
- Sets the RTSP DSCP (differentiated services code
point) value.
Alarm DSCP
- Sets the alarm DSCP (differentiated services code
point) value.
Network Traffic Out [kbit/s]
outgoing network traffic in kilobits per second.
Network Traffic In [kbit/s]
incoming network traffic in kilobits per second.
Configuring the Camera
- Indicates the current amount of
- Indicates the current amount of
55