Rtsp Tab - Basler BIP2-DXXXXc-dn User Manual

Configuring the Camera
3.7.2

RTSP Tab

Multicast On-Demand
"on-demand" stream. When multicast streaming on-demand is enabled, the camera will only deliver
a multicast video stream when one or more devices are requesting the multicast stream. This is an
additional bandwidth reducing mechanism.
Multicast IP
- If multicast streaming is enabled, sets the IP address for multicast streaming. The
Multicast IP address must be in the range from 224.0.1.0 to 239.255.255.255.
Multicast Port
- If multicast streaming is enabled, sets the port for multicast streaming.
Multicast TTL
- If multicast streaming is enabled, sets the multicast Time-To-Live (TTL). The
multicast Time-To-Live (TTL) value specifies the number of routers (hops) that multicast traffic is
permitted to pass through before expiring on the network.
Commit
- Click the Commit button to save any changes you have made to the RTSP settings.
Revert
- Click the Revert button to cancel any changes you have made to the RTSP settings. The
settings will revert to what they were the last time that the Commit button was clicked.
50
Enabled
- Check the Enabled box to enable the Real Time
Streaming Protocol (RTSP). RTSP is a control protocol that allows
the camera to negotiate which transport protocol to use for the video
streams. Typically, RTSP streaming should be enabled.
RTSP Port
- Sets the port that will be used by RTSP. The default
port is 554.
Multicast
- Check the Multicast box to enable multicast streaming.
Multicasting is a bandwidth conserving technology. It reduces
bandwidth by allowing the camera to deliver a single video stream to
multiple recipients on the network. Note that multicasting will only
work for streams where the Encoder Type parameter (see
Section 3.4.2 on page
- Check the Multicast On-Demand box to make the multicast stream an
29) is set to MPEG4 or to H.264.
Basler IP Fixed Dome Cameras
AW00101504000