BIG ASS FANS Element Installation Manual page 4

ii
WARNING—TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a.
b. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
CAUTION: The installation of a Big Ass
and with any additional requirements set forth by the national electric code (NEC), ANSI/NFPA 70-2011, and all local codes.
Code compliance is ultimately YOUR responsibility!
WARNING: The fan controllers contain high voltage capacitors which take time to discharge after removal of mains supply.
Before working on the fan controller, ensure isolation of mains supply from line inputs at the fan controller board (L1, L2/N).
Wait three minutes for capacitors to discharge to safe voltage levels. Failure to do so may result in personal injury or death.
CAUTION: Exercise caution and common sense when powering the fan. Do not connect the fan to a damaged or hazardous
power source. Do not attempt to resolve electrical malfunctions or failures on your own. Contact Big Ass Fans at 1-877-BIG-
FANS if you have any questions regarding the electrical installation of this fan.
Suitable for use with solid-state speed controls.
Fan supplied controllers that are marked (on their cartons) to indicate the suitability with this model. Other parts cannot be
substituted.
CAUTION: When service or replacement of a component in the fan requires the removal or disconnection of a safety device,
the safety device is to be reinstalled or remounted as previously installed.
from the power supply before servicing.
WARNING—TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
a. Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer.
b. Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
CAUTION: Do not bend the airfoils when installing or servicing the fan. Do not insert foreign objects between rotating airfoils.
WARNING: Stay alert, watch what you are doing, and use common sense when installing fans. Do not install fans if tired
personal injury.
CAUTION: The installation of this fan requires the use of some power tools. Follow the safety procedures found in the owner's
manual for each of these tools and do not use them for purposes other than those intended by the manufacturer.
CAUTION: The Big Ass Fans product warranty will not cover equipment damage or failure that is caused by improper
installation.
CAUTION: Do NOT install the fan where it may come into direct contact with water unless the fan is labeled, "Suitable for use
in wet locations."
These limits are designed to provide reasonable protection against harmful interference in a commercial installation. This equipment
• Reorient or relocate the receiving antenna.
•
•
•
negate your authority to operate the product.
Industry Canada statement
WWW.BIGASSFANS.COM
IMPORTANT SAFETY INSTRUCTIONS
READ AND SAVE THESE INSTRUCTIONS
FCC compliance statement
©2011 DELTA T CORP.
®
ELEMENT
Ass Fans must be installed with Big Ass
Ass Fans could void the EMC compliance and
DBA BIG ASS FAN CO. ALL RIGHTS RESERVED