Table of Contents
Advertisement
4026-0XX
Configuration Mode
The configuration mode gives the ability to set the following printer
functions through the operator panel:
Hex Trace
NPA Mode (Parallel)
Parallel Protocol
Advanced Status
PPDA Activated
Auto CRLF/LFCR
Perform the following steps to enter the configuration mode:
1. Turn the printer power off.
2. Open the top cover.
3. Turn the printer power on.
4. Top Cover Open (Error LED on) is displayed on the operator
panel.
5. Double-click the operator panel button.
6. The printer is in the configuration mode. The Ready LED is on
solid. The Data, Load Paper, Paper Jam, Error and Press But-
ton are off.
Note: Closing the top cover causes the printer to exit the configura-
tion mode. Repeat the steps to reaccess the configuration mode.
Configuration Mode Operator Panel Overlay
The following overlay indicates the operator panel LED and button
designations when in the configuration mode.
Hex Trace
NPA Mode
Parallel Protocol
Advance Status
CRLF/LFCR
Off/On/Auto
Press three seconds to save
Diagnostic Aids 3-10
Advertisement
Table of Contents
