HYT TC-508 Service Manual page 10

Software Specifications
communication with the programming software. In this mode, radio functions and adjustment parameters
can be set through the programming software (including User Version and Factory Version).
Wired Clone Mode
4.3.3
Description
Wired Clone Mode is an independent mode. To access other modes, you must restart the radio.
Wired Clone Mode includes Clone Mode and Factory Clone Mode.
1) User Clone Mode:
Connect two radios using a cloning cable. Power on the source radio while holding down SK1; the
radio will enter Clone Mode in approximately 2 seconds. Then directly power on the target radio to enter
the User Mode. In this mode, data stored in EEPROM of the source radio will be cloned to EEPROM of
the target radio. The data transferred only involves channel data and common parameters, excluding
tuning data, version and serial No. of the model.
2) Factory Clone Mode :
Connect two radios using a clone cable. Hold down both SK1 and Power On/Off Key of the source
radio, it will be turned on and will enter User Clone Mode by default after 2 seconds. Press SK
afterwards to switch to Factory Clone Mode. The target radio can be directly turned on to enter user
mode. The data transferred covers all data in EEPROM (including settings for the Manual Tune Switch),
other than the serial No.
Process
Step 1 The LED flashes red once after the source radio enters the Wired Clone Mode. Press PTT to
begin to clone data to the target radio.
Step 2 During cloning, LED of the source radio solidly glows red, and LED of the target radio solidly
glows green. When cloning is completed, LED of the source radio solidly glows green, and the
green LED of the target radio goes out, which indicates the preparation for another clone.
Step 3 If any abnormal situation occurs during cloning, the source radio will stop cloning and its
LED will flash orange, which indicates the preparation for another clone.
Step 4 When cloning is completed, the source radio goes back to standby status. Press PTT again to
begin another clone.
Manual Tune Mode
4.3.4
In this mode, you can manually tune the frequency deviation, power level and squelch level and etc.
Description of Tuning:
8
Service Manual