Changing Wax Guard For Receiver Tube - ReSound 60 series User Manual

Changing wax guard for receiver tube

2
1
For NP receivers:
1. Clean any debris from the old waxguard.
2. Insert the wand into the old waxguard.
3. Twist the wand with the waxguard in a clockwise direction to ensure it is attached to the wand.
4. Pull the wand and waxguard away from the tube/mould.
5. Insert the old waxguard into the center of the HF3 wheel.
6. Dispose of the old waxguard by drawing the wand to the narrow end of the center disposal area.
7. Insert the empty wand into a new waxguard on the HF3 wheel.
8. Pull the new waxguard attached to the wand away from the HF3 wheel.
9. Insert the wand into the receiver tube/mould.
10. Twist the wand to release the new waxguard onto the receiver tube/mould.
For S and HP receivers:
2
1. To remove the old wax guard, insert the removal side of the wax guard tool into the used wax guard
so that the shaft of the tool is touching the rim of the wax guard. Slowly pull the wax guard straight
out.
2. To insert the ne w wax guard, gently press the replacement side of the wax guard tool straight into
the hole of the sound outlet until the outer ring lies flush with the outside of the receiver. Pull the tool
straight out -the new wax guard will remain in place.
5
3 4
6 7 8 9 10
27