Qualcast GGT3001 Operating Instructions Manual page 8

head more sharply or try bumping it on a
firmer surface.
3. If there is no change in the cutting line
length, un-plug the trimmer's mains supply
cable. After the trimmer head stops rotating,
gently pull out the cutting lines manually.
Once the lines are pulled out (extended),
plug the trimmer mains supply cable back
into the power supply and resume cutting.
4. If the cutting line still does not feed from
the spool, the spool might be empty or the
cutting line may be tangled or jammed on
the spool. Un-plug the trimmer's mains supply
cable. After the trimmer head stops rotating,
remove the spool. If the line is tangled or
jammed, untangle and replace the line. If
the spool is empty, replace the spool.
K
TO REPLACE CUTTING LINE (See Fig L)
17
11
16
L
1. Turn trimmer over to access spool head
cover.
2. Press the release latch on the spool head
300 Watt
Electric Grass Trimmer
ORIGINAL INSTRUCTIONS
cover and remove cover, pulling it straight off
the cutting head assembly.
3. Lift the spool out of the spool housing.
REPLACE THE SPOOL
1. Replace the spool with a new factory pre-
wound spool.
2. Insert the end of one line through an eyelet
in the spool housing. Insert the other line
through the other eyelet.
3. Insert the spool into housing and press it
down gently until you feel it drop into place.
Take care to keep the line from becoming
trapped under the spool.
4. Snap the cutting head cover back on and
at the same time pull lines and be sure that
they are released from spool notch.
FILLING SPOOL WITH CUTTING LINE (Fig M)
1. Remove the empty spool from the tool
as described in "TO REPLACE CUTTING LINE"
above.
2. Remove any remaining cutting line from
the spool.
3. First wind new line onto the uppermost
part of the spool. Feed 1-2cm of cutting line
into one of the line spool notches. Wind the
cutting line onto the spool in the direction
of the arrow on the spool. Make sure to
wind the line neatly and in layers - VERY
IMPORTANT – DO NOT ALLOW THE LINE TO
CRISS CROSS WHILST WINDING IT ONTO THE
SPOOL. (See Fig M).
12
13
14
15
M
4. Repeat the above procedure for the
second cutting line on the lower section of
the spool.
HELPLINE NO 0844 8010979