Table of Contents
Advertisement
Metal sticker fitting instructions [S14V/S16V]
The drive format icon should also be fitted to the bezel before installation. The metal sticker sheet
supplied has Blu-ray, HD-DVD or DVD icons, depending on the format being used.
is free from dirt of grease. Peel and fold back the yellow backing sheet, revealing only the part you
wish to use.
C
arefully position the icon as central as possible, then apply even pressure over the
entire area. Peel off the plastic film (and unused icons) to reveal you handy work!
Optical disk drive (ODD) bezel installation [S14V/S16V]
The aluminum ODD bezel matches the finish of the case. The installation procedure requires
that the plastic drive bezel that comes fitted to your drive, be removed prior to installation.
Check that the drive has been aligned correctly and that the
Peel the back off the adhesive foam strip on the rear of the aluminium bezel. Fold a cardboard
spacer around each end of the bezel, holding your thumb against the flaps as shown. With the
tray closed, position inside the drive opening and press firmly against the front of the tray to
ensure good adhesion. Eject the tray to remove the spacers (a gentle tug may be required).
TOP
tray
can eject and close freely.
Ensure the bezel
TOP
foam
tape
5
Hide quick links:
Advertisement
Table of Contents
