SoftBank 924P User Manual page 27

3 Align Cover tabs with handset
slots, leaving a 2 mm gap
Slide Cover in direction of arrow
to shut completely
4 Make sure no gap remains between Cover and handset
⿟Keypad surface may inflate slightly when attaching Battery Cover. This is
not a malfunction; surface will gradually deflate. Use keypad as you
would normally; do not press with excessive force.
To manually relieve air pressure, first wipe off any moisture from handset
surface. Open External Port Cover to let out air then shut cover completely.
Precautions
■
Handset
⿟Do not leave handset wet.
• Doing so may cause short circuit on External Port.
• Water may leak into keypad or hinge. In cold climates, water
drops turn into frost; this may cause malfunction.
⿟Do not wash handset in a washing machine.
⿟Handset is not heat resistant. Do not immerse handset in hot
water, use it in a sauna or dry it with hot air using a dryer.
⿟Do not drop handset or subject it to excessive shock. Doing so
may deteriorate waterproof performance.
⿟Handset does not float in water.
⿟Use handset within temperatures of 5ºC to 35ºC and humidity
of 35% to 90% (handset use in temperature range of 36ºC to
40ºC should be kept to a minimum). Do not use or store
handset in extreme temperatures or under direct sunlight.
⿟Handset is not water-pressure resistant. Do not expose handset
to strong water flow or immerse it in water.
⿟Do not place handset directly on beach.
• Sand may enter Microphone, Earpiece or Speaker, impairing
volume.
• Water/sand inside handset may distort sound.
• Water leakage may occur if sand enters External Port Cover,
Inner Cover or Battery Cover.
Approx. 2 mm
■
External Port Cover/Inner Cover/Battery Cover
⿟Do not open/close External Port Cover, Inner Cover or Battery
Cover with gloves on. Small particles may adhere to rubber
packing.
⿟Make sure External Port Cover, Inner Cover or Battery Cover
areas are free of fine fibers after wiping off liquids.
⿟Do not remove rubber packing. Do not insert sharp-edged
objects into gaps around External Port Cover, Inner Cover or
Battery Cover. Doing so may cause water leakage.
⿟If External Port Cover or Inner Cover rubber packing is
damaged or deformed, replace with new packing.
■
Microphone/Earpiece/Speaker
⿟Do not pick Microphone, Earpiece or Speaker holes with
sharp-edged objects.
⿟Thoroughly wipe off water drops; may cause malfunction.
Draining Water from Handset
Even small amounts of water can seep in through keypad or
hinge, affecting Speaker/Earpiece volume or sound quality. Drain
water as follows:
1 Wipe water off handset with clean dry cloth
xxv