Preparation; Width Adjustment; Brakes; Charging Electric Motor - Dolomite STEP UP Manual Operating Instructions Manual

Table of Contents

Advertisement

DOLOMITE STEP UP
DOLOMITE STEP UP
1.
1.

Width adjustment

Lay the platform support down and then remove the
screw with Allen key no. 6. Adjust the side frame to
the width required and replace the screw, ensure that
it is properly tightened. (10 nM)
Repeat the procedure on the other side.
NB! The right and left side of the frame must
always be adjusted in/out by an equivalent
amount.
NB! Be aware of the risk of getting fingers
pinched when adjusting the side frame!!

2. Brakes

Press down the outer edge of the brake caliper until a
click is heard and the wheel is locked.
NB! Two of the wheels must be locked before
the user is assisted to or from the support
platform.
DOLOMITE STEP UP's leg-room can be varied
in 3 positions.
4

Preparation

2.

Product features

3
2
1
3.
3. Charging the electric motor
When the battery capacity is low, a warning signal
sounds indicating that it is time to charge the bat-
tery.
We recommend that the battery is fully charged
before the platform support is used for the first
time.
We also recommend that the battery is charged
regularly, e.g. every night, for maximum service life.
Connect the mains cable to the control unit and
the mains socket. When the battery is fully charged,
charging ceases automatically.
NB! Ensure that the emergency stop is
not pushed in when the motor is to be to
charged.
All brakes are easy to access thanks to the
design of the frame.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the STEP UP Manual and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents