Advertisement
GAD (90/396/EEC)
POTTERTON PROFILE lOOe G.C. No. 41 -607-49 (S.I.T. Control Valve)
POTTERTON PROFILE lOOe G.C. No. 41-605-65 (White Rodgers Control Valve)
IMPORTANT This appliance must be installed and serviced by a competent person as stated in the Gas Safety (Installation
and Use) Regulations 1994.
Profile boilers are certified for safety, it is therefore important that no external control devices (e.g. flue dampers,
economisers, etc.) be directly connected to these appliances unless covered by these installation instructions or otherwise
recommended in writing. Any direct connection of a control device not approved by Potterton could invalidate the certificate
and the normal warranty.
LIST OF CONTENTS - Page 2
General
Optional Extras
Accessories
Installation Data
Boiler Dimensions
GENERAL - Page 2
This Potterton Profile boiler is a fully automatically
controlled wall mounted fan powered balanced
flue appliance, using a cast iron heat exchanger
and is range rated from 23.44-29.3kW (80,000-
100,000 Btu/h) output.
The boiler which is designed to provide domestic
hot water and/or central heating must be used on
INDIRECT hot water systems only. The cast iron
heat exchanger, is suitable for use on open
vented gravity domestic hot water/pumped central
heating systems or fully pumped systems which
may be sealed or open vented.
OPTIONAL EXTRAS - Page 2
The following are kits available as optional
extras:-
Internal Fitment Kit, Part No. 225184, which is
suitable for a maximum wall thickness of 510mm
(2Oin.) is to be used where access to the outside
wall is impracticable.
Pump Cover Kit, located on top of the boiler and
designed to conceal the pump, and/or any
motorised valves installed above the boiler (Note:
Pump cannot be fitted above the boiler if the
vertical flue kit is used).
The following sizes are available:-
6in.
Part No.225418
7in. - l2in.
Part No. 225419
l3in. - l8in.
Part No. 225420
l9in. - 24in.
Part No.225421
Supplied By www.heating spares.co Tel. 0161 620 6677
Page No. 2
Site Requirements
Page No. 2
Technical Data
Page No. 3
Installation Instructions
Page No. 3
Commissioning
Page No. 3
Health and Safely Information
Control Systems, Pipework and
Wiring Guide
User's Instructions
The boiler can be supplied with either of the following types
of flue system, these are packaged with the terminal and
associated flue components.
1) Standard Horizontal flue system Part No. 225542.
Suitable for a wall thickness from 100mm (4in.) to 51
0mm (2Oin.).
2) 1 metre horizontal flue system Part No. 225545. Which
provides a maximum flue length of 955mm (37 in.).
3) 1 metre vertical flue system Part No. 213050. Which
allows the flue to pass through a flat roof and terminate
at a maximum height of 980mm (38in.) measured from
top of the boiler case.
Terminal Wall Plate, Part No. 212280, where necessary
can be fitted to the outside wall face to improve the
appearance, after making good around the terminal.
Terminal Guard, Part No. 205792, to be used when the
terminal is fitted less than 2m above a balcony, above
ground or above a flat roof to which people have access.
2
Page No. 3
Page No. 6
Page No. 11
Page No. 18
Back Page
Supplied in
Literature Pack
Advertisement
