Table of Contents
Advertisement
Jaguar Audio
2.6 Cabling Continued:
1. Lay all cables in their intended positions, separating control, audio, and
power cables wherever possible.
2. Provide proper support for each cable during the cabling process. The
use of tie-wraps is recommended.
2.7 Level Code (Strobe) Selection
The level (strobe) select switches, S3 (matrix A) and S6 (matrix B) are
located on the inside of the Jaguar Audio Routing Switcher on upper
middle and lower middle, respectively, of the backplane. For all switch
position to binary code conversions refer to Table 2-3.
Table 2-3 Switch Position to Binary Code Conversion
SWITCH POSITION TO BINARY CODE CONVERSION
SWITCH POSITION
Switch numbers are 1 through 8 right to left. Switches 1-6 select level
codes 1 through 62. Switches 7 and 8 are not used – their position is
unimportant. Refer to Figure 2-1 for an example of level code selection
and see Figure 2-2 for the physical location of the level code switches.
Physical 0 (Logical 1) = OFF (UP)
Physical 1 (Logical 0) = ON (DOWN)
3/98
P/N 81905903730
Installation
1
2
3
4
5
6
7
8
BINARY CODE
1
2
4
8
16
32
64
128
Section 2
2
INSTALLATION
page 2.5
Advertisement
Table of Contents
