Recording Using An External Timer Input - Sanyo TLS-S8000P Instruction Manual

RE4QS/EX (TLS-S8000P GB) Wed. May, 23/2001
RECORDING USING AN EXTERNAL TIMER
INPUT
Recording can be controlled by an external start/stop
signal input at the EXT TIMER IN terminal.
Example 3:
To record using the signal input at the
EXT TIMER IN terminal, in 24-hour
mode.
X Follow the Before starting steps, under "NORMAL
RECORDING".
NOTE:
X External timer input recording can only be set on the
9th line (EXT) of the (TIMER SET) menu.
1
Press the MENU button until the (TIMER SET)
menu is displayed.
2
Turn the JOG dial, until "EXT" (External) setting is
flashing.
Y The "SPD" (recording speed) position will start
flashing.
3
Turn the SHUTTLE ring to select the recording
speed mode (ex: 24), then turn the JOG dial
clockwise.
Y "N" will start flashing.
4
Turn the SHUTTLE ring to select "Y".
@@@@@@<TIMER@SET>
WEEK@START@@STOP@@@SPD
SUN@@--:--@@--:--@@---@N
MON@@--:--@@--:--@@---@N
TUE@@--:--@@--:--@@---@N
WED@@--:--@@--:--@@---@N
THU@@--:--@@--:--@@---@N
FRI@@--:--@@--:--@@---@N
SAT@@--:--@@--:--@@---@N
DLY@@--:--@@--:--@@---@N
EXT@@*****@@*****@@@24@Y
English
5
Follow steps F and G under "PROGRAMME
TIMER RECORDING on page 25".
Y When an external signal is input, "E" will light
on the digital display and recording will take
place.
NOTES:
X Other timer recordings using the standard procedure
can also be programmed.
X The external input signal must be input at the EXT
TIMER IN terminal.
29