Table of Contents
Advertisement
RE4QS/EX (TLS-S8000P GB) Wed. May, 23/2001
TAPE MANAGEMENT FUNCTION
Tape Management Conflict Display
If when the tape management function checks the tape
data a conflict that prevents recording is found, the
(TAPE MANAGEMENT) menu is displayed with the
conflicting setting flashing and the VCR go into stop
mode. If in the (SET UP 2) menu, WARNING is set to
"Y", the buzzer is heard. (To stop the buzzer, press the
STOP button.)
NOTES:
X If "OVERRIDE" is set to "N" (No), the conflicting
setting is displayed flashing and the message
(PRESS EJECT) is displayed at the bottom of the
screen. Recording under these conditions is not
possible. Press the EJECT button to eject the tape.
To record on the same tape, set the OVERRIDE
setting to "Y" and modify the conflicting setting, then
insert the same tape and press the REC button.
However, if only "PROTECT DAY" and "REC PASS
SET" are modified, the menu will be displayed again.
Press the REC button one more time to start
recording. Recording starts and the tape data is
updated.
Conflict display sample
@@@<TAPE@MANAGEMENT>
*TAPE@MANAGE.@@@@Y
*PROTECT@DAY@@@@@2
@LAST@D/M@@@@@@NEXT@D/M
@@@@@15/12@@@@@@@@@18/12
*REC@PASS@SET@@@@10
@PASS@COUNT@@@@@@10
*GROUP@NO.@@@@@@@7
@REC@GR.NO.@@@@@@8
*OVERRIDE@@@@@@@@N
@@@@@@(PRESS@EJECT)
X If the "OVERRIDE" is set to "Y" (Yes), the (TAPE
MANAGEMENT) menu is displayed and conflicting
setting preventing recording will flash and VCR go
into the stop mode.
To enter the record mode, press the REC button.
English
PROTECT DAY CONFLICT
The tape is protected, the tape protection term (ex. 2
days) is not yet over.
Under LAST D/M, the date of the last recording on
the tape (or the last expected recording date
(calculated using the tape length (E-180) and the
recording speed)) is displayed.
Under NEXT D/M, the date when it will be possible to
record on the tape again is displayed.
REC PASS SET CONFLICT
The set number of recording passes has been
reached.
The PASS COUNT shows the number of recording
passes on the tape (ex. since the maximum number
of recording passes is set to "10", this prevents
further recording.)
NOTES:
œ When conducting Autorepeat recording, if the
PASS COUNT exceeds 100, "101*" will be
displayed flashing.
œ If using a tape recorded previously on a different
type of VCR (no tape data), when the set number
of recordings is exceeded, "USED" will flash next
to the PASS COUNT number.
GROUP NO. CONFLICT
The group numbers do not match.
The REC GR. NO. shows the tape recording group
number (ex. this tape belongs to a different recording
group number 8 than the one set 7.)
17
Advertisement
Table of Contents
