Table of Contents
Advertisement
RE4QS/EX (TLS-S8000P GB) Wed. May, 23/2001
NORMAL RECORDING
Concerning the Number of Times Tapes
can be Rerecorded on
Depending on the recording speed mode, the tape must
be replaced after a certain number of recording times.
Refer to the table below for the maximum number of
times a tape can be recorded on.
Recording speed mode
(hour mode)
(with a standard grade
3
12, 24
48
72
96, 120
168, 240
360
480
720, 960
NOTES:
X The maximum number of recording times will vary
depending on the location and kind of tape used.
Verify the recording quality and replace the tape
when the quality starts to deteriorate.
The maximum number of recording times indicated
above are based on test tapes (E-180) used by the
company.
X If using longer tapes (i.e. E-240) the tape travel will
not be as stable and that may cause problems.
English
Changes to the Recording Speed Mode
During Recording
It is possible to permit or prevent changing the recording
speed mode during recording.
1
Maximum number of
recording times
tape)
100
50
2
25
3
15
10
5
3
2
4
1
Action to Take when the Video Signal
Deteriorates
If there is no video signal during recording or when a
menu is not displayed (in stop, fast forward or rewind
modes), "VIDEO LOSS" can be displayed on-screen
and a signal (0 V) can be output at the ALARM OUT
terminal. If in the (SET UP 2) menu, in the BUZZER
section WARNING is set to "Y", the buzzer will be
heard. To stop the buzzer, press the STOP button.
1
2
3
4
19
Press the MENU button until the (SET UP 4) menu
is displayed.
@@@@@@@<SET@UP@4>
*SW@OUT
@@TIMING@@@@@@@@FIELD
@@FIELD@@@@@@@@@01
@@3H@@@@@@@@@@@@Y
*THREAD@CHECK@@@Y
*VIDEO@LOSS@@@@@N
*REC@SPEED@@@@@@N
Turn the JOG dial, until the "REC SPEED" setting is
flashing.
Turn the SHUTTLE ring, to set the desired mode.
Y. . . . . . . . . . Recording speed mode can be
changed
N. . . . . . . . . . Recording speed mode can not
be changed
Press the SEARCH/AUDIO ON button to save the
setting.
Press the MENU button until the (SET UP 4) menu
is displayed.
Turn the JOG dial, until the "VIDEO LOSS" setting
is flashing.
Turn the SHUTTLE ring, to set the desired mode.
N. . . . . . . . . . The video loss warning is not
active.
Y. . . . . . . . . . The video loss warning is active.
Press the SEARCH/AUDIO ON button to save the
setting.
Advertisement
Table of Contents
