Turbo Mode (Automatic Transmission); Turbo Mode (Manual Transmission); Valet Mode (Via Switch) / Valet Coding; Valet Coding Disbaled (Default) - Command Start CS-PRO User Manual

TURBO MODE (AUTOMATIC TRANSMISSION)

Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the driver
leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the turbo-charger
to cool down. To activate Turbo Mode (automatic transmission) proceed with the following steps:
STEP 1
STEP 2
STEP 3
STEP 4

TURBO MODE (MANUAL TRANSMISSION)

Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the driver
leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the turbo-charger
to cool down. To activate Turbo Mode (manual transmission) proceed with the following steps:
See IDLE MODE (MANUAL TRANSMISSION) page 7.
V ALET MODE (VIA SWITCH) / VALET CODING
Valet Mode disables both the Remote-Starter and Alarm system. Whenever the vehicle is being serviced or
repaired, or the vehicle is parked indoors it is mandatory that Valet Mode be enabled to prevent an accidental
Remote-Start.
Note:
The alarm system is not active (including Starter Kill) when the system is in Valet Mode. However you
are still able to lock and unlock the doors, and release the rear hatch/trunk.
Note:
When the Remote-Starter/Alarm is in Valet Mode, the LED will stay ON solid instead of fl ashing after the
doors are locked. The LED will turn off only after the Remote-Starter/Alarm exit Valet Mode.
The valet mode can be programmed to use a coded entry in order to increase the security of your alarm system
and to prevent accidents. By default, the valet button is pressed 3 times after turning the ignition. Function
30 can be programmed to use a coded value instead of the default one.

VALET CODING DISBALED (DEFAULT):

To activate and deactivate Valet Mode using the valet switch proceed with the following steps:
STEP 1
STEP 2
STEP 3
Page 8 / 14
With the engine already running, press the remote START button 3 seconds
until the parking lights come on.
OFF
Remove the key from the ignition barrel.
The vehicle will continue to run with the the Remote-Starter.
Exit the vehicle and close all of the doors.
The vehicle will continue to run after all the doors are closed.
Press the LOCK button to lock the doors. The vehicle will continue to run
for 60 seconds.
Insert the key and turn it to the ignition (ON/RUN) position. The vehicle
does not need to be started.
Within 10 seconds press (1 second) and release the Valet switch 3
times.
Valet mode enabled: The LED is ON
Valet mode disabled: The LED is OFF