Accessory Preset; Ready Mode (Manual Transmission Only) - Command Start CS-PRO User Manual

Security system and remote car starter; automatic / manual transmission - 1-ways remote
Table of Contents

Advertisement

If the vehicle fails to start on the fi rst attempt, the Remote-Starter will wait 3 seconds be-
fore it will attempt to start the vehicle again. The Remote-Starter will attempt to start the
vehicle 2 times (default) before giving up. (See Failed Remote Start page 13)

ACCESSORY PRESET

Heater & Heated Seat(s):
climate controls in preparation for a later Remote-Start. When the vehicle Remote-Starts, the
current (or last) setting for the climate controls, windshield wipers (and other accessories) will be
used. When setting the blower motor (fan speed) and heated seats (if equipped) should not be
left on HIGH. It is recommended to leave these settings on either a LOW or MEDIUM setting.
Windshield Wipers & Radio & Headlights:
headlight circuits to become energized while running under Remote-Start. When leaving the ve-
hicle you must ensure that the windshield wiper and headlight switches are turned off. Leaving
the headlights on with some vehicles could cause them to remain on even after the Remote-Starter
has shut down, resulting in a dead battery.
Rear Defrost:
started and in most cases this feature is not included with a Remote-Starter installation. On
some vehicles it may be possible for the installer to hook this feature up so it either automatical-
ly enables after Remote-Start or can be enabled by using an AUX output. (See Auxiliary Outputs
page 10).
Driver Presets:
Different driver presets are not controlled by the Remote-Starter, however they may be controlled
with the Bypass/Interface Kit.

READY MODE (MANUAL TRANSMISSION ONLY)

Two activation methods are possible, please consult the salesman or installer to determine which of these
modes applies to your vehicle.
There are always safety concerns for a manual transmission vehicle to accidentally start while in gear, Ready
Mode alleviates these concerns. The driver must enable Ready Mode in order to Remote-Start the vehicle at
a later time. Once Ready Mode is set-up the vehicle can be started/stopped at will, as many times as needed.
However once the parking brake is disengaged, the hood is opened, or any of the doors are opened, Ready
Mode will deactivate and the vehicle will not start until Ready Mode is reactivated.
METHOD 1
PROGRAMMED BY DEFAULT THIS METHOD WILL ACTIVATE THE REMOTE CAR STARTER SEQUENCE ONLY WHEN
THE END USER IS USING THE REMOTE CAR STARTER REMOTE:
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
STEP 6
When leaving the vehicle it is recommended that the driver pre-set the
On most vehicles the Rear Defrost can only be activated after the vehicle has been
Some vehicles retain different seat, mirror and radio settings for each driver.
The vehicle must be running.
Make sure that all doors are closed and the transmission is in the
NEUTRAL position.
and
Engage the parking brake.
Release the brake pedal.
Press the START button for 3 seconds. The parking lights will fl ash
once and then remain on.
OFF
Remove the key from the ignition barrel.
The vehicle will remain running with the Remote-Starter.
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are closed.
Some vehicles require the radio, windshield wiper,
Page 5 / 14

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CS-PRO and is the answer not in the manual?

Questions and answers

Related Products for Command Start CS-PRO

Table of Contents

Save PDF