Subscribe to Our Youtube Channel
Related Manuals for Command Start CS-PRO
Summary of Contents for Command Start CS-PRO
- Page 1 SECURITY SYSTEM ONLY REMOTE CAR STARTER ONLY SECURITY SYSTEM AND REMOTE CAR STARTER AUTOMATIC / MANUAL TRANSMISSION - 1-WAYS REMOTE CS-PRO User Guide FCC ID : 2ACPMV340 DOC#: 20140922 REV:3 © 2014 ALL RIGHTS RESERVED...
-
Page 2: Table Of Contents
TABLE DES MATIÈRES TABLE OF CONTENTS TABLE OF CONTENTS ......................... 2 INTRODUCTION ..........................2 CAUTION - WARNING ......................... 3 NOTE ..............................3 INDUSTRY CANADA USER NOTICE ...................... 3 GOVERNMENT REGULATIONS ......................3 USING THE REMOTE CONTROL ......................4 REMOTE-STARTING ..........................4 REMOTE-STARTING THE VEHICLE ....................... -
Page 3: Caution - Warning
CAUTION - WARNING IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO: • ensure that the vehicle is parked in a safe and responsible manner. • ensure that the vehicle is not remotely started indoors (garage, underground parking). •... -
Page 4: Using The Remote Control
void the user’s authority to operate this device. USING THE REMOTE CONTROL The remote starter is equipped with two 1-way 4-button multi-channel remote control . TIME COMMAND DESCRIPTION PRESSED Locks all doors, arm the anti-theft system and activates the Alarm (if in- 0,5 SEC. -
Page 5: Accessory Preset
If the vehicle fails to start on the fi rst attempt, the Remote-Starter will wait 3 seconds be- fore it will attempt to start the vehicle again. The Remote-Starter will attempt to start the vehicle 2 times (default) before giving up. (See Failed Remote Start page 13) ACCESSORY PRESET Heater &... -
Page 6: Driving Off
METHOD 2 This method must be programmed by the installer during installation. THIS METHOD WILL ACTIVATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE VEHICLE. AUTOMATIC ACTIVATION: The vehicle must be running. STEP 1 Make sure the transmission is in the NEUTRAL position. STEP 2 Engage the parking brake. -
Page 7: Idle Mode (Manual Transmission)
Starter runtime expires. Press START any time the vehicle is running with the Remote-Starter to reset this timer. To activate Idle Mode (automatic transmission) proceed with the following steps: STEP 1 With the key in the barrel at the ignition (ON/RUN) position and the engine running, press the START button 3 seconds until the parking lights turn STEP 2 Turn the key to the OFF position and remove the key from the ignition barrel. -
Page 8: Turbo Mode (Automatic Transmission)
TURBO MODE (AUTOMATIC TRANSMISSION) Turbo Mode (if installed) is similar to Idle Mode but is used to cool down the turbo-charger once the driver leaves the vehicle. The Remote-Starter will continue run the vehicle for 2 minutes allowing the turbo-charger to cool down. -
Page 9: Valet Coding Enabled (Optional)
VALET CODING ENABLED (OPTIONAL): To activate and deactivate Valet Mode using the valet switch proceed with the following steps: STEP 1 Insert the key and turn it to the ignition (ON/RUN) position. The vehicle does not need to be started. STEP 2 Within 10 seconds press and release the valet button 3 to 7 times (X = valet code) for 1 second. -
Page 10: Auxiliary Use
To disable Cold Start Timer Mode do any of the following: • • • Simultaneously press and and hold the Put the Remote-Starter/alarm Turn the key to the ignition START and AUX buttons for 3 seconds. into Valet Mode. Remote-Start (ON / RUN) position. -
Page 11: Active Or Passive Arming
To LOCK the doors and ARM the Alarm: The parking light will fl ash once and the LED will turn ON to confi rm the signal. The Starter-Kill will activate preventing the vehicle from being started with the key. If LOCK is pressed again (consecutively) Press the LOCK but- Note: The system the horn will honk once (if installed) to confi rm. -
Page 12: Alarm Activity
ALARM ACTIVITY The following characteristics enhance your vehicle’s security : If the Alarm system is active and the horn/siren is sounding : • Press the UNLOCK button ONCE to stop the alarm sound. The Alarm will remain active and will im- mediately resound if a zone is (re)triggered. -
Page 13: Failed Remote-Start
FAILED REMOTE-START There are several different installation factors and devices that must work together in order for your vehicle to Remote-Start properly. In some cases a failed Remote Start is not the fault of the Remote-Starter itself. Here are some things to consider when the Remote-Starter fails. •... - Page 14 Page 14 / 14...
Need help?
Do you have a question about the CS-PRO and is the answer not in the manual?
Questions and answers