Driving Off; Cancelling A Remote Start; Remote-Starter Features; Idle Mode (Automatic Transmission) - Command Start CS-PRO User Manual

METHOD 2 This method must be programmed by the installer during installation.
THIS METHOD WILL ACTIVATE THE REMOTE STARTER SEQUENCE EVERYTIME THE END USER IS LEAVING THE
VEHICLE.
AUTOMATIC ACTIVATION:
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
The vehicle is ready to start. Open any door to cancel Ready Mode and start over the sequence from step 1
TO DEACTIVATE READY MODE:
•
Open any door(s)
Note : If the parking lights fl ash 3 times when Remote-Starting, Ready Mode is not enabled.

DRIVING OFF

When the vehicle is running with the Remote-Starter, enter the vehicle and proceed with the following steps:
STEP 1
STEP 2

CANCELLING A REMOTE START

See USING THE REMOTE CONTROL, page 4

REMOTE-STARTER FEATURES

IDLE MODE (AUTOMATIC TRANSMISSION)

Idle Mode allows the vehicle to run without the key in the ignition barrel. For example, if you stop for a quick
errand or delivery, simply allow the vehicle to run while you are gone. The engine will run until the Remote-
Page 6 / 14
The vehicle must be running.
Make sure the transmission is in the NEUTRAL position.
Engage the parking brake.
Release the brake pedal.
OFF
Remove the key from the ignition barrel. The engine continu to run.
Exit the vehicle and close all of the doors.
The Remote-Starter will stop running once all the doors are closed.
• Open the hood
Insert the key and turn it to the ignition (ON/Run) position.
Warning: Do not turn the key to the START position when
the engine is running. This may damage the ignition system
on some vehicles.
Step on the brake pedal to disable the Remote-Starter, and
put the vehicle in gear.
• Disengage of the parking brake
.