Caution - Warning; Note; Industry Canada User Notice; Government Regulations - Command Start CS-PRO User Manual

CAUTION - WARNING

IT IS THE RESPONSIBILITY OF THE REMOTE CAR STARTER OPERATOR TO:
• ensure that the vehicle is parked in a safe and responsible manner.
• ensure that the vehicle is not remotely started indoors (garage, underground
parking).
• ensure that the vehicle is not remotely started with a passenger inside.
• ensure that the gearshift lever is in the NEUTRAL position and the parking
brake is engaged on manual transmission in order to avoid accidents upon
remote starting.
• when leaving the vehicle, ensure that the gearshift lever is in the "PARK" po-
sition for an automatic transmission in order to avoid accidents upon remote
starting. (Note: Make sure that the vehicle cannot start in "Drive" position.)
• ensure that the remote starter is disabled or put into valet mode before ser-
vicing. When servicing the vehicle, enable
page 8

NOTE

•
The system can be confi gured in three different ways: Remote Start only, alarm only or alarm and
remote starter.
•
The options vary by vehicle, the components can be added to the system and the functions on the
vehicle.

INDUSTRY CANADA USER NOTICE

Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including inter-
ference that may cause undesired operation of the device. To reduce potential radio interference to other us-
ers, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (EIRP)
is not more than that required for successful communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifi ca-
tions to this equipment. Such modifi cations could void the user's authority to operate the equipment.

GOVERNMENT REGULATIONS

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful inter-
ference in a residential installation. This equipment generates and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is con-
nected.
•
Consult the dealer or an experienced radio/TV technician for help.
This device complies with the Industry Canada Radio Standards Specifi cation RSS 210. Its use is autho-
rized only on a no-interference, no-protection basis; in other words, this device must not be used if it is
determined that it causes harmful interferences to services authorized by IC. In addition, the user of this
device must accept any radio interface that may be received, even if this interference could affect the opera-
tion of the device.
Warning! Changes or modifi cations not expressly approved by the party responsible for compliance could
.
valet Mode (via switch) / VALET CODING,
Page 3 / 14