Active Or Passive Arming; Ignition Door Locks; Security Lock; Trunk/Hatch Release (Zone 6) - Command Start CS-PRO User Manual

To LOCK the doors and ARM the Alarm:
Press the LOCK but-
ton for second.

ACTIVE OR PASSIVE ARMING

Passive Mode will allow the Alarm to automatically rearm itself 60 seconds after it is disarmed if no door(s) (or
trunk) are open(ed). Opening a door before the 60 seconds has expired will reset the timer but will also prevent
the Alarm from locking the doors. This option is enabled by default and the Alarm will never arm as long as at
least one door is left open. When this feature is disabled the Alarm is considered to be in Active Mode which
requires the remote transmitter to arm the Alarm.
Note: The automatic rearm can be deactivated by pressing the UNLOCK button.

IGNITION DOOR LOCKS

Ignition Door Locks is an automatic passenger safety feature. When enabled the Remote-Starter/Alarm will
automatically LOCK the vehicles doors once the key is turned to the ignition (ON/RUN) position and the brake
pedal is pressed. The Remote-Starter/Alarm will also automatically UNLOCK the vehicles doors once the key
is turned to the OFF position.

SECURITY LOCK

Security Lock triggers the vehicle's door locks after the Remote-Starter has shut down. In some cases before
the Remote-Starter is able to start the vehicle it must disarm the Original Equipment Manufacture (OEM) anti-
theft system fi rst (if equipped) to prevent a false alarm when the vehicle is running. After the Remote-Starter
runtime has expired and the Remote-Starter shuts down, the Security Lock will re-arm the OEM anti-theft
system in order to return the vehicle to its original protective state.

TRUNK/HATCH RELEASE (ZONE 6)

The vehicle's trunk or rear hatch (if installed) can be opened by pressing the AUX button for 3 seconds.

RUNTIME

On gas engines the Remote-Starter can run the vehicle for either 3, 7 or 15 (default) minutes. On diesel en-
gines the Remote-Starter can run the vehicle for either 6, 15 or 30 (default) minutes.

RUNTIME RESET

Once the vehicle is running with the Remote-Starter the runtime can be reset (before it expires) at any time
by pressing the START button while the vehicle is Remote-Started. The horn/siren will sound once to confi rm
(If installed).

ALARM

AUDIBLE CONFIRMATION

By default the Alarm will not send an audible confi rmation (horn/siren) after the fi rst signal has been received
from the remote transmitter(s).
SILENT : Press the LOCK or UNLOCK button ONCE and the park lights will fl ash, but the
horn/siren will NOT confi rm the signal.
AUDIBLE : Pressing the same button TWICE consecutively (LOCK or UNLOCK) the park
lights will fl ash, and the horn/siren will confi rm the signal.
The Alarm can be programmed to audibly confi rm the signal on the fi rst button press. (See Installation
Guide).
The parking light will fl ash once and the LED will turn ON to confi rm
the signal. The Starter-Kill will activate preventing the vehicle from
being started with the key. If LOCK is pressed again (consecutively)
the horn will honk once (if installed) to confi rm.
can be confi gured during installation so the horn confi rms LOCK on
the fi rst attempt.
Note: The system
Page 11 / 14