Calibrate The Photolink Scanner; The Photolink Scanner Maintenance; Cleaning The Scanner - Pandigital PhotoLink PANSCN04 User Manual

Calibrate the
If the scanned image looks fuzzy or there are strange stripes on it,
the scanner may need calibrating in order for the sensor to
resume its original precision. To calibrate the scanner:
1. Follow the instructions beginning on page 26 to clean the
Note: Make sure that the calibration card is inserted in the
The
PhotoLink

Cleaning the Scanner

In order to maintain the scanned image quality and prevent
dust accumulation, it is recommended that you clean the
scanner (outer casing, image sensor and roller inside the
26
PhotoLink
roller and the image sensor, and then follow the
instructions under "Initial Setup" on page 13 to prepare the
scanner for scanning.
correct direction, and while the light is blinking,
otherwise the calibration won't work.
Scanner
2. Press the
the indicator light will blink.
3. Insert the calibration card as
shown (facing up with pattern
into the feed slot) while the
light is blinking.
The scanner will scan the pattern on
the calibration card and perform
calibration to the sensor inside
automatically.
Scanner Maintenance
CALIBRATION
button;